Advantech INTEL AIMB-210 User Manual
User manual aimb-210
Table of contents
Document Outline
- AIMB-210
- Contents
- 1 General Information
- 1.1 Introduction
- 1.2 Features
- 1.3 Specifications
- 1.4 Jumpers and Connectors
- 1.5 Board layout: Jumper and Connector Locations
- 1.6 AIMB-210 Board Diagram
- 1.7 Safety Precautions
- 1.8 Jumper Settings
- 1.9 System Memory
- 1.10 Memory Installation Procedures
- 2 Connecting Peripherals
- 2.1 Introduction
- 2.2 Parallel Port (LPT1)
- 2.3 Primary (IDE1) IDE Connector
- 2.4 USB Ports (LAN1_USB12/LAN2_USB34/USB56/ USB78)
- 2.5 TV-Out Connector (TVOUT1)
- 2.6 VGA Connector (VGA1)
- 2.7 Serial Ports (COM1~COM6)
- 2.8 PS/2 Keyboard and Mouse Connector (KBMS1)
- 2.9 CPU Fan Connector (CPU_FAN1)
- 2.10 System FAN Connector (CHA_FAN1)
- 2.11 Front Panel Connectors (JFP1/JFP2/JFP3)
- 2.12 Line In, Line Out, Mic In Connector (AUDIO1)
- 2.13 Serial ATA Interface (SATA1, SATA2)
- 2.14 PCI
- 2.15 Front Headphone Connector (FPAUD1)
- 2.16 ATX Power Connector (EATXPWR1)
- 2.17 SPI Flash connector(SPI_CN1)
- 2.18 LCD Inverter Connector INV1 & INV2 (Optional)
- 2.19 LVDS Connector LVDS1 & LVDS2 (Optional)
- 2.20 Digital I/O Connector (DIO1)
- 3 BIOS Operation
- 3.1 Introduction
- 3.2 BIOS Setup
- 3.2.1 Main Menu
- 3.2.2 Standard CMOS Features
- 3.2.3 Advanced BIOS Features
- 3.2.4 Advanced Chipset Features
- 3.2.5 Integrated Peripherals
- 3.2.6 USB Device Setting
- 3.2.7 Security Chip Configuration (Optional Item)
- 3.2.8 TPM Support
- 3.2.9 Power Management Setup
- 3.2.10 PnP/PCI Configurations
- 3.2.11 PC Health Status
- 3.2.12 Frequency/Voltage Control
- 3.2.13 Load Setup Defaults
- 3.2.14 Set Password
- 3.2.15 Save & Exit Setup
- 3.2.16 Quit without Saving
- 4 Chipset Software Installation Utility
- 5 VGA Setup
- 6 LAN Configuration
- A Programming the Watchdog Timer
- B I/O Pin Assignments
- B.1 Parallel Port (LPT1)
- B.2 USB Header (USB56, USB78)
- B.3 VGA Connector (VGA1)
- B.4 RS-232 Interface
- B.5 RS-232/422/485 Setting Interface (JETCOM2)
- B.6 SPI_CN1: SPI Fresh Card Pin Connector
- B.7 PS/2 Keyboard and Mouse Connector (KBMS1)
- B.8 CPU Fan Power Connector (CPU_FAN1)
- B.9 System Fan Power Connector (CHA_FAN1)
- B.10 Power LED & Keyboard Lock Connector (JFP3)
- B.11 HDD LED and External Speaker Connector (JFP2/HDD LED and SPEAKER)
- B.12 ATX Soft Power Switch and Reset Connector (JFP1/ PWR-SW and RESET)
- B.13 ATX Power Connector (EATXPWR1)
- B.14 USB/LAN ports (LAN1_USB12/LAN2_USB34)
- B.15 Line In, Line Out, Mic In Connector (AUDIO1)
- B.16 Serial ATA0/1 (SATA1/SATA2)
- B.17 AT/ATX Mode (PSON1)
- B.18 AC-97 Audio Interface (FPAUD1)
- B.19 GPIO Pin Header (GPIO1)
- B.20 LVDS Connector: LVDS1 & LVDS2 (Optional)
- B.21 LVDS Power Jumper (JLV1, JLV2)
- B.22 LVDS Invert: INV1 & INV2 (Optional)
- B.23 System I/O Ports
- B.24 DMA Channel Assignments
- B.25 Interrupt Assignments
- B.26 1st MB Memory Map
- 1 General Information