DAVIS Wireless Repeater WITH SOLAR OR AC-POWER - Manual (Page 7)

Single Transmitter, Single Repeater Installation Page 7
4. When you find a location that works, switch all three units out of test
mode.
If the transmitter is in test mode, restore to normal mode to conserve
power. If you’re using a Vantage Pro console/receiver, use Setup mode to
temporarily deactivate all transmitter IDs. Similarly, to switch the repeater
out of test mode, flip the Repeater ID DIP switch #4 from the TEST position
to the off position as shown below.
Repeater DIP Switch Set to TEST MODE OFF
Note: Leaving the repeater in test mode will cause the LEDs to flash unnecessarily and thus drain
additional power from your power supply. Use the test mode only when necessary.
5. Remove power from the repeater.
For AC models, make sure you unplug both primary and battery power.
Repeater ID Code
DIP Switches
1 ON
REPEA
TER ID
234
TEST