DAVIS Wireless Repeater WITH SOLAR OR AC-POWER - Manual (Page 16)

Product Numbers: 7624 & 7625
Davis Instruments Part Number: 7395.105
Wireless Repeater with Solar or AC-Power
Rev. E (September 9, 2003)
This product complies with the essential protection requirements of the EC EMC Directive 89/336/EC.
Copyright © 1999-2003 Davis Instruments Corp. All rights reserved.
3465 Diablo Avenue, Hayward, CA 94545-2778
510-732-9229 • Fax: 510-732-9188
E-mail: [email protected] • www.davisnet.com
Specifications
Operating Temperature . . . . . . . . . . . . . . . . . . . . .-40° to +150°F (-40° to +65°C)
Non-operating Temperature . . . . . . . . . . . . . . . . . .-50° to +158°F (-45° to +70°C)
Current Draw . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.5 mA at 4-6 VDC
Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6.25" x 2.25 " x 7.875 " (158.75 mm x
57.15 mm x 200 mm)
Wireless Communications
Transmit/Receive Frequency . . . . . . . . . . . . . . . . . .US Models: 916.5 MHz,
Overseas Models: 868.35 MHz
ID Codes Available . . . . . . . . . . . . . . . . . . . . . . . . .8
Output Power . . . . . . . . . . . . . . . . . . . . . . . . . . . .916.5 MHz: FCC-certified low power, less
than 1 mW, no license required
868.35 MHz: CE-certified, less than 10 mW,
no license required
Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Line of Sight - up to 400’ (122 m)
Through Walls - 75 to 150’ (23 to 46 m)
FCC Part 15 Class B Registration Warning
This equipment has been tested and found to comply with the limits for a class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
✦
Reorient or relocate the receiving antenna.
✦
Increase the separation between the equipment and receiver.
✦
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
✦
Consult the dealer or an experienced radio/TV technician for help.
Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC reg-
ulations. Changes or modifications not expressly approved in writing by Davis Instruments may void
the user's authority to operate this equipment.