DAVIS Wireless Repeater WITH SOLAR OR AC-POWER - Manual (Page 4)

Page 4 Wireless Repeater
Note: If you’re using only one transmitter, one repeater, and one console, all three devices are set at
the factory to broadcast and receive on Davis ID code #1. You won’t need to change anything,
unless you’ve got a neighbor broadcasting on the same ID code.
Choosing a Location
The range of the radio transmission depends on several factors.
Note: Given the maximum ranges below, the repeater may need to be somewhat closer to the
receiver than to the transmitter.
Typical maximum ranges between the transmitter and the repeater:
✦ Line of Sight: 400 feet (120 m)
✦ Through Walls and Ceilings: 150 feet (46 m)
✦ Through Trees and Foliage: 150 feet (46 m)
Typical maximum ranges between the repeater and the receiver:
✦ Line of Sight: 400 feet (120 m)
✦ Through Walls and Ceilings: 75 to 150 feet (23 to 46 m)
✦ Through Trees and Foliage: 75 to 150 feet (23 to 46 m)
AC-Powered Repeaters
Look for a sheltered location with access to an AC-power outlet. For
example, you could mount the repeater in a room or garage.
Solar-Powered Repeaters
Look for a location where you can position the solar panel to receive maxi-
mum exposure to the sun’s rays as follows:
✦ The solar panel works best when the surface of the panel receives
full sunlight. Mount the panel away from fences, buildings, trees or
other obstructions that may cast shadows over the panel.
✦ The solar panel should be mounted facing south in the Northern
Hemisphere and north in the Southern Hemisphere for maximum
sun exposure.
You can use a compass or a local map to help find north and south.