PowerTap Pro User Manual
Page 14
14
POWERTAP STANDARD INTERVAL MODE/POWERTAP STANDARD COMPUTER SET UP
Interval Mode
The Powertap Interval mode functions differently than the previous Powertap computers. It works as
a lap marker, and is essentially always on. To begin the first interval, or advance the interval, simply
press both buttons down simultaneously from any location or mode in the display. “INT” and the new
interval # will briefly appear, before disaapearing again to the background. To view interval specific
information (duration, distance, averages, etc) simply hold down the mode button for two seconds.
This brings interval mode to the foreground. “INT” and the interval number will constitute a fourth line
in the display (see picture at right). When you wish to relegate the interval information to the back-
ground again, simply depress the mode button for two seconds.
Interval Memory Mode
To access stored interval information selcet “INT” by pushing mode until “INT” blinks. Then hold
select for 2 seconds until M appears next to the interval number indicating you are now viewing inter-
val information. Push select to advance to the interval you wish to view and push mode to select the
information you wish to view. (Ave. watts, cadence, etc.)To exit Interval Memory Mode hold mode for
2 seconds. Note that recovery periods as well as work periods are displayed in memory mode.
Interval Shortcut
To quickly mark intervals simply push both buttons simultaneously from either trip or interval mode.
If in trip mode “INT” will briefly appear indicating you have marked an interval and which number
interval you are on.
watts
speed
int
multi
Std
t
Std
t
Press select but-
ton to select 12 or
24 hour clock.
Press mode but-
ton to save.
Press select button to
select AM(A) or PM(P).
Press mode button to
save.
p
12
Powertap Standard Computer Set Up