PowerTap SLC+ User Guide - Manual (Page 41)

Power seems incorrect
·Torque value is not zeroed. To manually zero torque, go to current watts and hold down the
[SELECT] button until watts disappears. Torque is now being displayed. To zero torque hold
down the [SELECT] button until the value reads zero. To exit torque mode press [SELECT]
once.
If re-zeroing the torque does not recalibrate the unit, call Saris Cycling Group customer
service at 1-800-783-7257.
Speed seems incorrect
· Wheel size incorrect -refer to setup 1 and enter the correct size in setup mode.
Transmission icon flashes rapidly
· Hub batteries need replacement - replace the hub batteries as shown in the maintenance
section of the User Manual.
Warranty
CycleOps PowerTap is warranted to the original retail purchaser to be free from defects in
materials and workmanship. Warranty coverage is valid to the original purchaser only and
proof of purchase will be required.
Electronics - 1 year
This warranty does not cover:
1. Normal wear and tear.
2. Any damage, failure or loss caused by accident, misuse, neglect, abuse, improper assembly,
improper maintenance, or failure to follow instructions or warnings in Owner’s Manual.
3. Use of products in a manner or environment for which they were not designed.
41