PowerTap SLC+ User Guide - Manual (Page 31)

COMPUTER SETUP 5
This setup allows the CPU to learn a new device or sensor such as the hub, heart rate strap
and optional cadence sensor. NOTE: This process only needs to be used if a new sensor or
hub is being used in conjunction with your CPU or vice versa. There are 2 Learn sequences, 1
and 2. Learn 1 is used when you have switched sensors or the CPU and there are no other like
bikes with PowerTap within a 30’ radius. Learn 2 is used if there are other devices in the area
but requires you to remove and reinsert the battery for that device before activating the
Learn 2 sequence.
1) From the computer setup main menu press [SELECT] and scroll until
the number five (5) is flashing and press [MODE] to enter setup mode.
2) Press [SELECT] to toggle through the digit values to set the Hub ID.
Press [MODE] to advance to the next digit. After the last digit is set,
press [MODE] to save.
Note: Use either Learn 1 or Learn 2 to set the hub ID when the
numberical value is not known. (Most cases) Make sure the hub is awake
by spinning the wheel or axel.
3) Initiate Learn 1 by holding [SELECT] until “Learn” begins to flash.
Learn 1 will search for any active hub so be sure there are no other
native hubs in the area. When the search is complete press [MODE] to
advance to Learn 2.
Note: If Learn 1 was successful, learn 2 is not necessary.
4) Initiate Learn 2 by first removing the batteries from the hub for 5
seconds and replacing them. Then hold [Select] until "Learn" begins to
flash. When the CPU has learned the hub I.D. it will display the I.D.
Press [Mode] to save and proceed to the next device I.D. If it did not learn
the device it will take you back to the most recent Hub I.D.
31
hub
Id
45847
hub
Id
LEArn
1
hub
Id
LEArn
1
flashing
hub
Id
LEArn
2
hub
Id
LEArn
2
flashing
Set
E
1 2 3 4 5
t
d