PowerTap SLC+ User Guide - Manual (Page 23)

Computer Setup
The setup feature has five(5) main modes. You do not have to
complete all five to change settings. Please reference each
mode to determine the correct location to begin. NOTE: The
computer illustrations for each mode displays the factory
default settings.
COMPUTER SETUP MAIN MENU
1) Press either [MODE] or [SELECT] to activate the computer.
NOTE: The version of firmware is displayed upon startup. The
most updated firmware version is available at
www.cycleops.com. (FIGURE 28)
2) Extended hold of [MODE] and [SELECT] simultaneously
enters computer setup function. NOTE: Continue to hold
through “clr” screen. Releasing hold early will clear all current
data.
3) The setup mode displays three (3) letters and numbers 1-5.
Each letter represents a setup menu. A flashing alphanumeric
character indicates current selection. (FIGURE 29)
E = exit, return to ride mode
d = restore default settings
T = test mode
1 2 3 4 5= setup menus
Note: Only the SLC+, SL+, Pro+ and 2.4+ have setup menus 2, 3
and 4.
4) Press [SELECT] to scroll to the desired setup mode.
5) Press [MODE] to begin setup.
23
Set
1 2 3 4 5
FIGURE 29
Pro
5 . 3 3
FIGURE 28
E
t
d
Note: The new pro-
duction version
will mark 6.0 ver-
sion of firmware.