PowerTap SLC+ User Guide - Manual (Page 29)

COMPUTER SETUP 4
This setup menu includes: sleep time, locations of display, cadence source, cycle computer
mode, heart rate monitor, and auto start/stop. From this menu you are unable to move back
to previously viewed settings. You must restart setup 4 to make corrections.
1) From the computer setup main menu press [SELECT] and scroll until
the number four (4) is flashing and press [MODE] to enter setup mode.
2) Press [SELECT] to set how many minutes the computer will stay
“awake” after not receiving a valid speed or heart rate signal. Press
[MODE] to save. NOTE: The shorter the sleep time the longer the battery
life.
3) Press [SELECT] to determine what is displayed in the middle line. (mi =
speed, c = cadence, (
) = heart rate). Press [MODE] to save. The selected
metric will flash during the ride. NOTE: If heart rate or cadence is select-
ed speed is not displayed. This is useful for intervals when power, heart
rate and cadence are most important.
4) Press [SELECT] to determine cadence information source.
Default = pedal then hub
Pedal = crank only
Hub = hub only
NOTE: An optional cadence sensor is available (sold separately).
Press [MODE] to save.
29
PRO
4
4
SLEEP
PRO
4
mi
PRO
4
p e d a l
c
Hu
P
Set
E
1 2 3 4 5
t
d