PowerTap SLC+ User Guide - Manual (Page 10)

3. Place Computer into Shoe
Place the computer into the computer shoe on the handlebar or stem.
Line up the slots on the base of the computer with the bracket and slide
computer toward the rider (FIGURE 5). NOTE: Ensure the computer is
fully inserted onto the receiver shoe to prevent accidental removal.
4 Heart Rate Monitor Strap (SLC+, SL+ and PRO+ only)
Position the heart rate monitor strap on your torso as pictured in
FIGURE 6. The strap should rest just beneath the pectoralis muscles
of the chest. For best results slightly moisten the electrodes where
contact is made with skin. The heart rate strap must be worn to
enable the heart rate function. NOTE: The chest strap for the
PowerTap uses a coded frequency and is not compatible with other
manufacturer’s chest straps. If heart rate is not displayed, consult
finding sensors section.
5. Verify Installation
Check to make sure all components are properly secured. Spin
the rear wheel and verify transmission. To turn computer on
press either button. The computer system may require 30 sec-
onds to “find” the hub. The illuminated transmition icon in the
upper left hand corner of the display indicates the hub is proper-
ly transmitting a signal to the computer (Figure 7). If the trans-
mission icon is not illuminated consult Finding Sensors Section for
further instructions.
10
FIGURE 5
FIGURE 6
FIGURE 7