PowerTap SLC+ User Guide - Manual (Page 39)

4 - Standard Test File
This mode writes a small test file to the memory. Press [SELECT] and the bottom lines says
“run” and then “yes” when the file is written. This file can then be downloaded.
5 - Communication Loop Back Test
When looking at the front side of the computer, use a coin or paper clip to short out the two
pins on the left side. Press [SELECT]. The bottom line will say “run” and then “yes” if it passes
the test correctly. If the pins are not shorted together or there was a problem, the display will
say “no”. This test can be repeated by pressing [SELECT].
6 - Fast Memory Test
This tests the memory in the computer. Press [SELECT] and “run” is displayed on the bottom
line. When the test is completed and it passes, it says “yes”. If the test should fail, the bottom
line will say “no”.
39