Ag Leader InSight SC Seed Tube Monitor (STMM) - Manual (Page 12)

Part No. 2002831-47 Rev. B 12
Section 9: Seed Tube Monitor Module
Setup
Press the Seed Monitor Setup button on the Implement Tab to summon the Seed
Monitor Setup window, as shown below. Here you may adjust row and ground speed
source settings, adjust sensor configuration and set alarm thresholds.
Note: New settings entered at this screen are sent directly to the Seed Tube
Monitor Module; thus you do not need to enter new configuration settings for each
planting implement unless the number of rows change.
Seed Monitor Setup
Shows the number of rows found on the planter that the Seed
Tube Monitor Module supports. Use the up and down arrows
to enter the total number of rows found on the planter.
Shows the selected Ground Speed Source input for the Seed
Tube Monitor Module.
Press the Sensor Configuration button to summon the
Sensor Configuration window, which shows which rows are
assigned to the individual pins on the Seed Tube Monitor
Module. For more information, see “Seed Tube Sensor
Configuration” on Section 10, page 13; and also “Seed
Monitor Sensor Selection” on Section 11, page 14.
Press the Alarms button to summon the Seed Monitor Alarms
window, which shows each row and the alarm threshold for
that row. For more information, see “Seed Monitor Alarms”
on Section 12, page 15.