HP LaserJet M2727 Multifunction Printer series - Manual (Page 91)

Change the default 2-Sided setting
1. On the product control panel, press Setup .
2. Use the arrow buttons to select Copy setup, and then press OK .
3. Use the arrow buttons to select Default 2-sided, and then press OK .
4. Use the arrow buttons to select the option for how you normally want to use the automatic duplexer
when you copy documents.
5. Press OK to save the selection.
Copy two-sided documents manually
Set the multiple-page flatbed copy setting
The multiple-page flatbed copy setting must be set to On before the product will produce two-sided
copies from the flatbed scanner.
1. On the product control panel, press Setup .
2. Use the arrow buttons to select Copy setup, and then press OK .
3. Press OK to select Def. Multi-page.
4. Use the arrow buttons to select On or Off.
5. Press OK to save the selection.
NOTE: The factory-set default for automatic copy collation is On.
The Collate LED on the control panel is on when collation is on.
Copy two-sided documents manually
1. Load the first page of the document on the flatbed scanner.
2. Press 2-Sided , and then use the arrow buttons to select the correct setting.
3. Press OK , and then press Start Copy .
4. Remove the first page, and then load the second page onto the flatbed scanner.
5. Press OK , and then repeat the process until all of the pages in the original have been copied.
6. When the copy job is completed, press Start Copy to return the product to Ready mode.
ENWW Duplex (two-sided) copy jobs 79