Set the default glass-size setting, Set tone-dialing or pulse-dialing – HP LaserJet M2727 Multifunction Printer series User Manual
Page 120
Set the default resolution setting
1.
On the control panel, press
Setup
.
2.
Use the arrow buttons to select Fax setup, and then press
OK
.
3.
Use the arrow buttons to select Fax Send setup, and then press
OK
.
4.
Use the arrow buttons to select Def. Resolution, and then press
OK
.
5.
Use the arrow buttons to change the resolution setting.
6.
Press
OK
to save the selection.
Set the resolution for the current fax job
1.
On the control panel, press
Resolution
to show the current resolution setting.
2.
Use the arrow buttons to select the appropriate resolution setting.
3.
Press
OK
to save the selection.
NOTE:
This procedure changes the fax resolution for the current fax job. For instructions about
changing the default fax resolution, see
Set the default resolution setting on page 108
.
NOTE:
To change the fax contrast or glass-scan size, you must change the default settings. See
the default light/dark (contrast) setting on page 107
Set the default glass-size setting on page 108
Set the default glass-size setting
This setting determines which paper size the flatbed scanner scans when you send a fax from the
scanner. The factory-set default is determined by the country/region in which you purchased the product.
1.
On the control panel, press
Setup
.
2.
Use the arrow buttons to select Fax setup, and then press
OK
.
3.
Use the arrow buttons to select Fax Send setup, and then press
OK
.
4.
Use the arrow buttons to select Def. Glass size, and then press
OK
.
5.
Use the arrow buttons to select the correct paper size setting: A4 or Letter.
6.
Press
OK
to save the selection.
Set tone-dialing or pulse-dialing
Use this procedure to set the product to tone-dialing or pulse-dialing mode. The factory-set default is
Tone. Do not change this setting unless you know that the telephone line cannot use tone dialing.
1.
On the control panel, press
Setup
.
2.
Use the arrow buttons to select Fax setup, and then press
OK
.
3.
Use the arrow buttons to select Fax Send setup, and then press
OK
.
4.
Use the arrow buttons to select Dialing Mode, and then press
OK
.
5.
Use the arrow buttons to select Tone or Pulse, and then press
OK
to save the selection.
108 Chapter 10 Fax
ENWW