Configure trays, Change tray selection, Configure trays change tray selection – HP LaserJet M2727 Multifunction Printer series User Manual
Page 63
Configure trays
When using one of the trays for specific size of paper, you can set the default size for the tray in
HP ToolboxFX or from the control panel. In HP ToolboxFX, select Paper handling, and then select the
size for the tray you want to set. When you select that size of paper for a print job in the print dialog, the
product automatically selects that tray for printing.
To set the default paper size or type from the control panel, complete the following steps.
1.
On the product control panel, press
Setup
.
2.
Use the arrow buttons to select System setup, and then press
OK
.
3.
Use the arrow keys to select Paper setup, and then press
OK
.
4.
Use the arrow keys to select the tray to be configured, and then press
OK
.
5.
Use the arrow keys to select either Paper type or Paper size, and then press
OK
.
6.
Use the arrow keys to select a default type or size for the tray, and then press
OK
.
Change tray selection
The product is set to automatically pull media from trays that contain media. The product always pulls
media from tray 1 if you insert media into tray 1. If there is no media in tray 1, the product attempts to
pull media from tray 3, if installed, and then from tray 2.
You can specify which tray you want to use by changing the tray selection. Auto select, Tray 1, Tray
2, and Tray 3 are available settings. Auto select will pull media from the first available tray with the
appropriate matching media loaded.
NOTE:
Tray 3 is only available if a tray 3 is installed.
Change the tray selection for the current job
1.
On the product control panel, press
Tray Select
.
2.
Use the arrow buttons to select the input tray that you want to use.
3.
Press
Start Copy
to save the selection and immediately start the copy job, or press
OK
to save the
selection without starting the job.
Change the default tray selection
1.
On the product control panel, press
Setup
.
2.
Use the arrow buttons to select Copy setup, and then press
OK
.
3.
Use the arrow buttons to select Def. Tray Select, and then press
OK
.
4.
Use the arrow buttons to select a tray setting, and then press
OK
.
ENWW
Configure trays
51