HP Insight Management Agents - Manual (Page 145)

•
TimeOffset—In the format of +/- XX:XX:XX (hour:minute:second). To do a set, modify the value
in the predefined format in the text field, and click SET.
•
BlockShift—An integer typeset. Modify the value in the text field, and click SET.
•
Trigger—An integer typeset. Modify the value in the text field, and click SET.
In NetWare 4.x, all the sets done through command line or Monitor utility take effect immediately,
but the sets are lost when the server is rebooted. The Web Agent overcomes this drawback by
writing the SET command in Autoexec.ncf when a set is committed through the Web Agent browser
so it is a permanent set. In NetWare 5.x, the SET command is not added in the Autoexec.ncf,
because the operating system can remember the set even after the reboot.
SET exceptions
In both NetWare4.x and NetWare 5.x, when the administrator or operator tries to do a SET on
a variable that is only settable through the Startup.ncf file, a SET XXXXX=XXXX line is added in the
Startup.ncf
file. Although, the SET does not take effect until the remote server is restarted, when
SET is clicked, a warning message appears.
In NetWare 5.x, when trying to do a lower-than-current-value SET on alert message nodes, an
HTTP post error warning appears. Be alert, because the operating system is denying this SET. If
this SET is done through the command line or Monitor utility, the same denial occurs.
Physical Partition page
The Physical Partition page displays a table of physical partitions for long-term storage devices
contained by the host. The table on the Physical Partition page is sorted by the Type value by
default.
•
Type (sortable)—The type of this physical partition. The types listed can be:
NetWare ◦
◦ DOS
◦ InwDos
◦ Other
•
Description (sortable)—A brief description of this partition.
•
Size (sortable)—The size (in Kilobytes) of this physical partition.
Adapter Information page
The Adapter Information page displays general information for each adapter board in the host.
The Adapter table is sorted by the Description value by default.
Description—A description of the hardware information for the adapter. The description usually
includes manufacturer, model, and version information. For LAN adapters, the short board name
and the burnt-in MAC address of the boards are listed.
Physical Partition page 145