HP 120 Color Copier - Manual (Page 14)

10 Chapter 3—Load paper or transparency film, or load originals
HP Color Copier
Load originals on the glass
You can process any original by placing it on the glass.
1
Lift the lid, and make sure that the glass is clean.
For more information, see “Clean the glass.”
2 Place the original face down on the glass with the top edge along the green border,
and align the upper-right corner of your original with the top of the white arrow and
the end of the green border.
If you are copying a photo, place the short edge of the photo along the green border,
and align the corner of the photo with the top of the white arrow and the end of the
green border.
If you are copying from a transparency (that is, your original is printed on
transparency film), place a blank piece of paper on top of the transparency.
3 Close the lid.
Load originals in the automatic document feeder (ADF)
When using the ADF, be aware of the following:
•
To prevent paper jams, use 16-24 lb. (60-90 gsm) plain paper or HP Premium Inkjet
paper only. Also, use only letter-, A4-, or legal-size originals.
• To avoid a paper jam, do not load colored originals printed on a color laser printer,
photos or photo papers, transparency film, labels, envelopes, or slick-surfaced
papers, such as glossy papers.
• You can load a maximum of 30 originals at a time when using letter- or A4-size
papers.
Top edge of original
Cam.book Page 10 Friday, February 25, 2000 11:32 AM