HP ProLiant DL580 G3 Server - Manual (Page 111)

Memory options 111
8.
Close the ejector lever, and lock the locking switch.
9.
Power up the server ("Powering up the server" on page
37 ).
10.
Configure the memory ("Configuring the memory" on page
111 ).
11.
Reference the memory board LEDs ("Memory board components and LEDs"
on page 12 ) to be sure that the memory board is functioning properly.
Configuring the memory
Configuring the memory system of the server requires configuring both hardware
and software.
To configure the memory:
1.
Install the correct amount of memory for the desired AMP mode. For a list of
AMP options, refer to "Memory Options (on page 95 )." For more
information, refer to "General Memory Configuration Requirements."
2.
Test the DIMMs for all AMP modes, except Advanced ECC, before
configuring the AMP mode in RBSU. The two testing methods are:
– POST memory test (on page
112 )
– ROM-Based Diagnostics test ("ROM-based diagnostics" on page
112 )