HP ProLiant DL580 G3 Server - Manual (Page 108)

108 HP ProLiant DL580 Generation 3 Server User Guide
7.
Close the ejector lever, and lock the locking switch.
NOTE: The board status LED might flash green for several
minutes while the board is rebuilding.
8.
Configure the memory ("Configuring the memory" on page
111 ) if
applicable.
9.
Reference the memory board LEDs ("Memory board components and LEDs"
on page 12 ) to be sure that the memory board is functioning properly.
Removing and installing a memory board (non-hot-plug)
1.
Power down the server ("Powering down the server" on page
37 ).
2.
Unlock the locking switch, and open the release latch.