HP Photosmart C4344 All-in-One Printer - Manual (Page 101)

To remove the print cartridge from the print cartridge protector
▲ Press down on the top of the print cartridge protector to release the print cartridge,
and then gently remove the print cartridge out of the print cartridge protector.
Remove ink from your skin and clothing
Follow these instructions to remove ink from your skin and clothing:
Surface Remedy
Skin Wash the area with an abrasive soap.
White fabric Wash the fabric in cold water and use chlorine bleach.
Color fabric Wash the fabric in cold water and use sudsy ammonia.
CAUTION: Always use cold water to remove ink from fabric. Warm or hot water can
set the ink into the fabric.
Ink-backup mode
Use the ink-backup mode to operate the HP All-in-One with only one print cartridge. The
ink-backup mode is initiated when a print cartridge is removed from the print cartridge
cradle.
During ink-backup mode, the product can only print jobs from the computer and print
received faxes. You cannot initiate a print job from the control panel (such as printing a
photo from a memory card).
NOTE: When the HP All-in-One operates in ink-backup mode, a message is
displayed on the computer. If the message is displayed and two print cartridges are
installed in the device, verify that the protective piece of plastic tape has been
removed from each print cartridge. When plastic tape covers the print cartridge
contacts, the device cannot detect that the print cartridge is installed.
This section contains the following topics:
• Ink-backup mode output
• Exit ink-backup mode
Chapter 12
98 Maintain the HP All-in-One
Maintain
the HP All-in-One