HP StorageWorks 2300 Disk System - Manual (Page 90)

90 Configuration
Setting Up the Hardware Event Monitor
Separate monitors watch over the disks and the disk system. You need to install
and configure the Disk Monitor (disk_em) and the High Availability Storage
System Monitor (dm_ses_enclosure) for complete event notification.
To install and configure the required monitors, refer to the EMS Hardware
Monitors User’s Guide, which is included in Adobe Acrobat format on IPR
Support Media. You can download a copy of Acrobat Reader without charge
from http://www.adobe.com/prodindex/acrobat/readstep.html.
For specific information about setting up hardware event monitoring using HP
CommandView SDM, see the HP Commandview SDM Disk System Installation
and User Guide, Version 1.04 (Part Number T1001-96006).
For specific information about setting up hardware event monitoring using HP
TopTools 5.5, see the HP TopTools 5.5 User Guide, Version 1.0 on the following
URL:
http://www.hp.com/toptools/doc/manuals.html.
Aliasing Devices (HP-Qualified Only)
Using host-based software, you can “label” each disk system with any
information that would be useful for the site. You might use this feature to assign
an inventory number or to indicate the location of the product. The maximum
length of the annotation is 256 characters. It appears in EMS event messages.
For specific information about annotating devices, see the HP Commandview
SDM Disk System Installation and User Guide.
For specific information about annotating devices using HP TopTools 5.5, see the
HP TopTools 5.5 User Guide.