beautypg.com

Figure 57, Power supply removal and replacement 124 – HP StorageWorks 2300 Disk System User Manual

Page 124

background image

124 Removal and Replacement

5

Slide the replacement power supply into the empty slot (D in Figure 57). The
power supply begins to engage the midplane with 3/8 inch (8mm) still
exposed.

6

Rotate the handles back toward the center of the power supply module to
draw the power supply the last 3/8 inch into the chassis and firmly seat the
power supply on the midplane. The power supply should be flush with the
edge of the chassis.

7

Tighten the thumbscrews on the power supply handles (A and B). It is
recommended that you use a screwdriver to ensure proper seating.

8

Plug the power cord into the power supply and electrical source.

9

Monitor the power supply LED. It should turn green. If the LED is dark or
stays amber, see Chapter 4, Troubleshooting.

See also other documents in the category HP Storage: