HP Insight Management Agents User Manual
Page 48
•
Drive Type—Indicates the type of physical drive. The following values are valid:
SCSI—The physical drive is a parallel SCSI drive.
◦
◦
SATA—The physical drive is a Serial ATA drive.
◦
SAS—The physical drive is a Serial attached SCSI drive.
◦
Unknown—The Storage Agents cannot determine the drive type.
•
Media Type—Indicates the type of media the physical drive is composed of. The following
values are valid:
◦
Rotating Platters—Indicates that the physical drive media is composed of rotating platters.
◦
Solid State—Indicates that the physical drive media is composed of solid state electronics.
◦
Unknown—Indicates that the Storage Agents cannot determine the media type.
•
Maximum Temperature—Indicates the maximum temperature in degrees Celsius that the drive
has reached.
•
Current Temperature—Indicates the current drive temperature in degrees Celsius.
•
Temperature Threshold—Indicates the temperature in degrees Celsius at which the drive says
it is overheated.
•
Negotiated Link Rate—Displays the negotiated link rate for SAS and SATA physical drives.
The possible values are:
◦
1.5 Gbps—The negotiated link rate for this drive is 1.5 gigabits per second.
◦
3.0 Gbps—The negotiated link rate for this drive is 3.0 gigabits per second.
◦
6.0 Gbps—The negotiated link rate for this drive is 6.0 gigabits per second.
◦
Unknown—The agent is unable to determine the negotiated link rate for this drive.
•
NCQ Support—Displays the status of Native Command Queuing support for this drive. The
possible values are:
◦
No Controller Support—The array controller does not support NCQ.
◦
No Drive Support—The array controller does support NCQ, but the drive does not.
◦
Disabled—The array controller and drive support NCQ, but it is disabled.
◦
Enabled—The array controller and drive support NCQ and it is enabled.
◦
Unknown—The agent is unable to determine the NCQ configuration for this drive or it
is not a SATA drive.
•
Phy Count—Displays the number of phys for each physical drive. Single-ported drives have
one phy. Dual-ported drives have two phys.
•
Multipath Status—Displays the overall multipath status of this physical drive. The following
values are valid:
◦
Not Configured—Indicates that the physical drive is not configured to have multipath
access.
◦
Redundant—Indicates that the physical drive currently has more than one I/O path to
the controller.
48
Agent information