HP Insight Management Agents - Manual (Page 56)

◦ Ready rebuild—Indicates that the logical drive is ready for Automatic Data Recovery. The
physical drive that failed has been replaced, but the logical drive is still operating in
Interim Recovery Mode.
◦ Rebuilding—Indicates that the logical drive is currently doing Automatic Data Recovery.
During Automatic Data Recovery, fault tolerance algorithms restore data to the replacement
drive.
◦ Wrong drive—Indicates that the wrong physical drive was replaced after a physical drive
failure.
◦ Bad connect—Indicates that a physical drive is not responding.
◦ Overheating—Indicates that the drive array enclosure that contains the logical drive is
overheating. The drive array is still functioning, but should be shutdown.
◦ Shutdown—Indicates that the drive array enclosure that contains the logical drive has
overheated. The logical drive is no longer functioning.
◦ Transforming—Indicates that the logical drive is currently undergoing a transformation
(expansion, shrinkage or movement). During transformation, fault tolerance algorithms
redistribute logical drive data according to the transformation operation selected.
◦ Not available—Indicates that the logical drive is currently unavailable. If a logical drive
is expanding and the new configuration frees additional disk space, this free space can
be configured into another logical volume. If this is done, the new volume is set to not
available.
◦ Queued for transformation—Indicates that the logical drive is ready for transformation
(expansion, shrinkage or movement). The logical drive is in the queue for transformation.
◦ Multipath access degraded—Indicates that all the physical drives in the logical drive were
previously accessible by at least two paths, but now at least one physical drive within
that logical drive is accessibly by only a single path due to a hardware fault or a hardware
configuration change (e.g. mistakenly replacing a dual ported drive with a single ported
drive.)
◦
Erasing—Indicates that the logical drive is currently being erased.
◦ Predictive Spare Rebuild Ready—Indicates that the logical drive is ready to perform a
predictive spare rebuild.
◦ Rapid Parity Initialization—Indicates that the logical drive is currently undergoing rapid
parity initialization (RPI). The logical drive is unavailable to the operating system during
RPI and will be made available once RPI has completed.
◦ Rapid Parity Initialization Pending—Indicates that the logical drive is currently pending
rapid parity initialization and will be unavailable.
◦ Unknown—You may need to upgrade your software.
56 Agent information