HP EML E-series Tape Libraries - Manual (Page 77)

5 Moving the library
This section explains how to move or ship the library. To ship the library, or move it using a motor
vehicle (for example, truck, or forklift), follow the instructions in this section. To move the library to
a new location within the same building or facility, follow all instructions in this section except for
those found in
(page 78) .
CAUTION: Moving or shipping the library without proper packaging materials can result in
damage to library components. HP strongly recommends that an HP authorized service representative
move a library to another location.
NOTE: These procedures require the original packaging materials of the library. If you do not
have the original packaging materials, contact your support representative for ordering information.
Selecting an installation location
When choosing an installation site for the library, consider the requirements in the following
sections.
Preparing the library for a short move
1. Remove all tape cartridges from the tape drives using your application software.
2. Roll the library carefully on level surfaces to its destination.
Preparing the library for long-distance relocation
1. Use your application software to remove all tape cartridges from the tape drives.
2. Remove all tape cartridges from the library slots.
3. Carefully pack all tape cartridges for shipment.
4. Install the shipping straps on the robot.
5. Push the yellow gear lock up to prevent movement of the reduction gear.
2. Yellow gear lock 1. Shipping straps
Selecting an installation location 77