HP EML E-series Tape Libraries - Manual (Page 28)

2 Using the library
This chapter describes operating procedures for the library.
Powering on the library
1. Close the center door of the library and turn the center-door knob one-quarter turn clockwise
to lock it.
Figure 24 Closing the center door
2. At the back of the library, press the library main power switch to the I (On) position.
Figure 25 Library main power switch control
1. Library main power switch
NOTE: The following step applies only when the library is powered on for the first time or
when a new interface controller is installed. This step is necessary to put the interface controller
into managed mode.
28 Using the library