HP EML E-series Tape Libraries - Manual (Page 47)

Table 15 Indicators on the switch for the internal network (continued)
Function Control/indicator Index
No.
On--The port is enabled and receiving a link indication from the connected
device. Off--The port has no active network cable connected, or is not receiving
link signal. Flashing--Indicates that there is network activity on the port. Link/Act 3
FDx--When the FDx (full duplex) indicator LED is on, the port Mode LEDs turn on
for those ports that are operating at full duplex. Speed--When the Speed indicator Mode 4
LED is on, the port Mode LEDs for ports 1--22 are lit for ports that are in 100
Mbps mode and are off for ports operating at 10 Mbps. The port Mode LEDs
for ports 23--24, are lit for ports that are in 100 or 1000 Mbps mode or are off
for ports operating at 10 Mbps.
Library main power switch
Figure 45 Control on the library main power switch
Table 16 Control on the library main power switch
Function Control/indicator Index No.
When switched On (I), powers on all library power supplies. Switch 1
When switched Off (O), places all library power supplies
in standby mode.
Controls and indicators 47