HP EML E-series Tape Libraries - Manual (Page 25)

Figure 20 Slot numbering in the base module for all other EML configurations
2. Array targets for the barcode scanner 1. Robot park zone
4. Software demarcation between upper and lower modules
for slot counting purposes 3. Reserved slots-can be used for cleaning cartridges or
data cartridges
6. Slots unavailable for use when the library floor is installed
in this module 5. Slots available for data cartridges
8. Expansion identification label 7. Tape drives
10. Column numbering 9. Row numbering
12. 8U base module 11. Load port slots
14. Tape drive numbering 13. 4U base module
Figure 21 Slot numbering in the tape drive expansion module
2. Array targets 1. Slots available for data cartridges
4. Tape drive numbering 3. Slots unavailable for use when the library floor is installed
in this module
6. Expansion identification label 5. Tape drives
8. Column numbering 7. Row numbering
9. Load port slots
Numbering 25