Optional protection settings, Limiting bandwidth for a protection job – HP Storage Mirroring Software User Manual
Page 53

51 of 195
Optional protection settings
When you are creating a protection job, you will have an opportunity to configure
optional job settings when you get to the Protection summary workflow page. If you
want to configure optional settings, click Configure next to the options section.
●
Compressing data for transmission for a protection job
●
Limiting bandwidth for a protection job
●
Routing transmission for a protection job
●
E-mailing repository server event messages
Compressing data for transmission for a protection job
To help reduce the amount of bandwidth needed to transmit Storage Mirroring Replicate
data, compression allows you to compress data prior to transmitting it across the
network. In a WAN environment this provides optimal use of your network resources. If
compression is enabled, the data is compressed before it is transmitted from the source.
When the repository server receives the compressed data, it decompresses it and then
writes it to disk.
By default, compression is set to None, which means it is disabled. The compression
levels can be set at Minimum, Medium, or Maximum. Each level requires more
overhead than the previous level of compression. If you notice an impact on performance
while compression is enabled in your environment, either adjust to a lower level of
compression or leave compression disabled.
Limiting bandwidth for a protection job
Bandwidth limitations are available to restrict the amount of network bandwidth used for
Storage Mirroring Replicate data transmissions. When a bandwidth limit is specified,
Storage Mirroring Replicate never exceeds that allotted amount. The bandwidth not in
use by Storage Mirroring Replicate is available for all other network traffic.