HP Storage Mirroring Software - Manual (Page 126)

124 of 195
ID Category Severity Event Message Required Response
5002 Service Info.
Placeholders were
modified to %1.
No action required.
5100 Failover Info. Failover completed for %1. No action required.
5101 Failover Info.
IP address %1 with subnet
mask %2 was added to
target machine's %3
adapter.
No action required.
5102 Failover Warning
%1 has reached a failover
condition. A response from
the user is required before
failover can take place.
User intervention has
been configured. Open
the Failover Control
Center and accept or
decline the failover
prompt.
5103 Failover Info.
Started adding drive shares
from %1 to %2.
No action required.
5104 Failover Info.
%1 drive shares were taken
over by %2.
No action required.
5105 Failover Info.
Attempting to run the %1
script.
No action required.
5106 Failover Info.
The %1 script ran
successfully.
No action required.
5107 Failover Error
Error occurred in running
%1 script.
Verify that the script
identified exists with the
proper permissions.
5108 Failover Error
The source machine %1 is
not responding to a ping.
This occurs when all
monitored IP addresses
on the source machine
stop responding to pings.
Countdown to failover
will begin at the first
occurrence and will
continue until the source
machine responds or
until failover occurs.