HP Storage Mirroring Software - Manual (Page 194)

192 of 195
Storage Mirroring Replicate ports
Storage Mirroring Replicate port information is stored in configuration files. By default,
ports 80, 6320, 6330, and 6340 are used. If you are using TimeData continuous data
protection, the default ports are 8080, 17001, 17101, 17201, and 17301. If desired you
can modify some of these ports. However, not all of the ports can be modified.
If you have to modify which ports are used, you will have to modify two configuration
files. Be careful when modifying these configuration files. If you modify them incorrectly,
Storage Mirroring Replicate may no longer work correctly.
1. Open the file JobMgr.dll.config in your Storage Mirroring Replicate installation
directory. By default, this is \Program Files\StorageWorks\Storage Mirroring. You
may need to associate the .config file extension with Notepad or another text
editor.
2. Locate the following lines near the top of the configuration file.
3. Change the port numbers as necessary. Do not change any other information.
4. Save the configuration file.
5. Repeat steps 1 through 4 with the file BackupConsole.exe.config, using the same
port numbers for each key as you used in the JobMgr.dll.config file.
6. Repeat steps 1 through 5 for each Storage Mirroring Replicate server. The ports
must match between all Storage Mirroring Replicate servers and clients.
7. If you changed the IdentificationPort in the configuration files, you must also
change a port in the Replication Console.
a. Select Start, Programs, Storage Mirroring , Storage Mirroring Replication
Console.
b. Locate your server in the server tree in the left pane of the Replication
Console.
Note:
If your server is not listed, select Insert, Server. Type the machine name
or IP address and click OK.
c. Double-click the server to log on to it.