HP Storage Mirroring Software - Manual (Page 39)

37 of 195
Installing and configuring Ontrack PowerControls
1. Depending on your Storage Mirroring Replicate installation selections, the Ontrack
PowerControls installation may automatically launch immediately following the
TimeData installation. If it did not start automatically or if you are installing it
separately from the Storage Mirroring Replicate installation, start the Ontrack
PowerControls installation program using the appropriate instructions, depending
on your media source.
●
CD—Load the Storage Mirroring Replicate CD into the local CD-ROM drive.
If auto-run is enabled, the installation program will start automatically. To
manually start the program, select Start, Run and specify drive>:\setup\Ontrack PowerControls\Ontrack PowerControls.exe.
●
Web download—Unzip the .exe file that you downloaded from the web to a
temporary location and select Start, Run and specify location>\setup\Ontrack PowerControls\Ontrack PowerControls.exe.
2. At the Welcome screen, click Next.
3. Review and accept the license agreement by clicking Yes.
4. Specify your User Name and Company Name and click Next to continue.
5. Select the directory where you want to install Ontrack PowerControls and click
Next to begin the installation.
6. Click Finish to exit the installation program.
7. After the installation is complete, you need to configure Ontrack PowerControls to
use your repository server. Select Start, Programs, Kroll Ontrack, Ontrack
PowerControls for Storage Mirroring, Ontrack PowerControls for Exchange.
8. Cancel the Data Wizard when it appears.
9. Select Help, About, and click License Info.
10. Specify the name of your Storage Mirroring Replicate repository server. You can
also click the browse button (the button with ... on it) to select the name from a
network drill-down list.
11. Click Close to save the server information.
12. Click OK to close the About box.