HP NonStop G-Series - Manual (Page 62)

Service Displays the name of the tested service (read-only).
Parameters displayed Tracks the parameters displayed in the window (read-only).
Parameter text fields The parameter information text entry field. These fields are writable or read-only. Disabled if read-only.
RUN Runs the test with the data entered.
Clear Clears the text entry field.
Next Lists additional parameter fields, if applicable.
Prev Lists previous parameter fields, if applicable.
Back Returns to the Edit Services window.
Testing a Service Process Flow
Test a service to ensure that all service and parameter information is correct. You can test a service without making changes to the
service or its parameters. You can also test a service after editing the service or its parameters.
Figure 5-13 shows a typical Repository Editor service test flow.
Figure 5-13. Test Service Flow
Testing a Service Instructions
Select Services from the Logon window to display the Services window. 1.
Select the package and the service to test. 2.
Select Edit to access the Edit Services window. 3.
Select Test to access the Service test window. 4.
Input data in the Service test window parameter text field. 5.
Select RUN. The status line displays the message Run Completed OK if the test passes, or Call Failed if the test fails. See
Some Reasons Why a Test Might Fail or Table 5-1 for additional Repository Editor troubleshooting information.
6.
Follow these instructions if editing is required to pass the test.
Return to the Repository Editor logon window and select Packages. 1.
Select the package with the services to be retested. 2.
Select Unexport. 3.
Select Back to return to the Logon window. 4.