HP NonStop G-Series - Manual (Page 24)

[-XC cmp-thresh] Enable application data sent between a Jolt client and a Jolt
server (JSH) to be compressed during transmission over the
network. cmp-thresh is a number between 0 and
2147483647. Any messages that are larger than the
specified number of bytes are compressed before
transmission. The default is 0 (no compression); that is, if
cmp-thresh is not specified, Jolt does not compress
messages on client or server. (Optional)
[-x mpx-factor] A parameter used to control the degree of multiplexing
within each JSH process. This is the number of clients that
one JSH can service. Default value is 10. (Optional)
[-Z 40|128] When establishing a network link between a Jolt client and
the JSH, allow encryption up to this level. 40 and 56/128
specify the length (in bits) of the encryption key. The
default value is 0. The length, 128, is synonymous with
56/128. See
Security and Encryption for more information.
Shutting Down the Jolt Server
All shutdown requests to the Jolt servers are initiated by the TUXEDO command, tmshutdown -y. During
shutdown:
No new client connections are accepted. ●
All current client connections are terminated. TUXEDO will rollback in-flight transactions. Each client
receives an error message indicating that the service is unavailable. ●
Using the Jolt Repository
The Jolt Repository contains TUXEDO service definitions that allow the Jolt clients to access TUXEDO
services. The Jolt Repository files included with the installation contain services definitions used internally by
Jolt. See
Section 5, Using the Jolt Repository Editor for detailed instructions on how to add definitions to the
application services.
Configuring the Jolt Repository
To configure the Jolt Repository, modify the application UBBCONFIG file. See the NonStop TUXEDO
Reference Manual for information regarding the syntax of the entries for the file.
Example 3-2 shows relevant
portions of the UBBCONFIG file.
Example 3-2. Sample UBBCONFIG File for JREPSVR