HP LaserJet M4345 Multifunction Printer series - Manual (Page 94)

4. Load the media into the tray.
NOTE See Load letterhead, prepunched, or preprinted paper for information about
loading preprinted, letterhead, and prepunched paper.
5. Adjust the left media guide by pressing the tab on the guide and sliding the guide until it gently
touches the media stack
6. Adjust the front media guide by pressing the tab on the guide and sliding the guide until it gently
touches the media stack.
7. Look at the package for the ream of paper. Note the value of the width (X dimension) and the
length (Y dimension). You will need this information for a later step.
8. Close the tray.
9. If the size that appears on the control panel is Custom , then the tray size is set to ANY
CUSTOM . The tray will match any custom-size print job, even if the print-job dimensions are
different from the dimensions of the media that is loaded in the tray. If you prefer, you can
82 Chapter 4 Media and trays ENWW