Initial setup menu, Networking and i/o – HP LaserJet M4345 Multifunction Printer series User Manual
Page 44
Initial Setup menu
The
Initial Setup
menu contains the sub-menus shown:
●
Networking and I/O
menu
●
Fax Setup
menu
●
E-mail Setup
menu
NOTE
Values shown with "(default)" are the factory-default values. Some menu items have
no default.
Networking and I/O
Table 2-9
Networking and I/O
Menu item
Sub-menu item
Values
Description
I/O Timeout
Select a value in the
range. The factory
default setting is
15 seconds.
I/O timeout refers to the elapsed time before a print
job fails. If the stream of data that the device
receives for a print job gets interrupted, this setting
indicates how long the device will wait before it
reports that the job has failed.
Parallel Input
NOTE
This
item appears
only if an EIO
accessory is
installed.
High Speed
No
Yes
(default)
Use the
High Speed
setting to configure the speed
that the parallel port uses to communicate with the
host.
Advanced Functions
Enabled
(default)
Disabled
Use the
Advanced Functions
setting to enable or
disable bidirectional parallel communication.
Embedded Jetdirect
See
for the list of options.
EIO
Table 2-10
Jetdirect menus
Menu item
Sub-menu item
Sub-menu item
Values and Description
TCP/IP
Enable
Off
: Disable the TCP/IP protocol.
On
(default): Enable the TCP/IP protocol.
Host Name
An alphanumeric string, up to 32 characters, used to
identify the device. This name is listed on the
HP Jetdirect configuration page. The default host
name is NPIxxxxxx, where xxxxxx is the last six
digits of the LAN hardware (MAC) address.
IPV4 Settings
Config Method
Specifies the method that TCP/IPv4 parameters will
be configured on the HP Jetdirect print server.
Bootp
: Use BootP (Bootstrap Protocol) for automatic
configuration from a BootP server.
32
Chapter 2 Control Panel
ENWW