HP NonStop G-Series User Manual
Page 87
Removes power to the disk drive.
Power On
Restores power to the disk drive.
Reset Backup Path
Places the backup path in a state from which it can be started.
Reset Disk
Places the disk in a state from which it can be started. This action might be necessary before starting
a disk that has both paths in a Hard Down state; if a hardware error has occurred; if the disk was
stopped with an Abort action; or if a Stop or Abort fails to put the disk into the Down state.
If only one disk path is in a Hard Down state, you can use the
Reset Primary Path
Places the primary path in a state from which it can be started.
Reset Volume
Places the volume in a state from which it can be started.
Responsive Test
Verifies that the disk drive is installed and responding.
Start Backup Path
Starts the backup path to this disk drive. When the Start action completes, the backup path is in the
Started state.
This action fails if both paths to this disk are down and the mirrored disk is Up. For more
information, see
.
Start Disk
Use this action to start all paths to the disk drive only when:
The disk paths are in a Down state. (Hard Down states require a reset action, either
as appropriate.)
●
Its mirrored disk is not currently Up. The Start Disk action is designed to fail if the mirrored
disk is already in an Up state because the mirror and primary disk volumes can have different
data and require a revive operation. To revive and bring up the disks properly, use the OSM
●