Actions, Switch group, Attributes – HP NonStop G-Series User Manual
Page 222
Enabled State
The initial state of the component at the time of discovery.
Enabled: The component is operational.
Disabled: The component is present but not operational, possibly because the
Disable action was performed.
Device State
Indication of whether the fan has a fault.
Values: OK, Fault
Actions
Blink LED Off
Turns off the blinking of the fault LED.
Blink LED On
Causes the fault LED to blink on and off.
Switch Group
connected together, typically mounted in a rack, that
reside on one fabric of a cluster switch zone. The switch group is identified by a four-digit
number. The first two digits (10) distinguish a switch group from a group within a NonStop
S-series server. The third digit represents the zone number of the switch group, and the fourth
digit indicates the external ServerNet fabric where the switch group is located (0 for the X
fabric and 1 for the Y fabric).
Location in OSM tree: External ServerNet Fabric > Switch Group
Example: Switch Group 1020 (The switch group in zone 2 on the X fabric)
Attributes
Switch Group
Service State
Displayed in the Attributes tab and Attributes dialog box only if attention or
service is required.
Logical
Presence
Whether the switch group is installed and responding.
Values: Present, Absent, and Unknown