HP NonStop G-Series - Manual (Page 150)

or result in personal injury.
Restrain any dangling items that can get caught in electromechanical equipment,
such as long hair and sleeves, before working with the equipment. ❍
Unpack and inspect the replacement power supply. Use a flashlight to examine the pins on the
power supply's backplane connector for any damage. If any pins are bent or broken, you must
order another power supply (or have the backplane connector repaired or replaced) before
continuing with this procedure. Refer to Avoiding Connector and Backplane Damage During
CRU/FRU Replacement on the
CSSI Web .
2.
Removing the Power Supply
Remove the front panel from the power shelf. 1.
Locate the power supply you are removing (power supplies are in slots 31 and 32). At this
point, the LED above the power supply you are removing might or might not be lit. This
illustration shows an S7x000 processor enclosure. For an illustration of an IOMF2 CRU, see
the NonStop S-Series Hardware Installation and FastPath Guide. 2.