HP NonStop G-Series - Manual (Page 117)

Alter Interface Type
Allows you to set the Configured Interface Type to either Autodetect, Copper, or Fiber.
Fiber is a valid option only for PIF C or D. (The action fails if you select Fiber for PIF A or B.)
In most cases, the Autodetect option will work. However, if you have a fiber cable connected to one
of the PIF ports and a copper cable to the other, and you want to use the copper cable, you must
specify Copper (because autodetect checks for the presence of a fiber cable first).
Configure LIF
Configures the associated LIF.
Start
Starts the G4SA PIF. The PIF must be in the Stopped state before you perform this action. When the
Start action completes, the PIF is in the Started state.
Stop
Rather than automatically stopping the G4SA PIF (as the Abort action does), this action first warns
you if the PIF is currently in use (and stops it only after you confirm).
G4SA SAC
A ServerNet addressable controller mounted on a G4SA (Gigabit Ethernet 4-port ServerNet adapter).
Each G4SA SAC contains up to four G4SA PIF s, which correspond to the four Ethernet ports on
each G4SA.
Location in OSM Tree: System > Group > IOAM Enclosure > IOAM > G4SA > G4SA SAC
Example: G4SA SAC $ZZLAN.G4SA1.0
Attributes
G4SA SAC
Service State
Displayed in the Attributes tab and Attributes dialog box only if attention or service is
required.
Values
Logical