Switch authentication, Setting switch user information – HP StorageWorks XP Remote Web Console Software User Manual
Page 55

3.
In the Port tree, double-click the Subsystem folder.
If the storage system contains any Fibre Channel adapters, the Fibre folder displays below
the Subsystem folder.
4.
In the Port tree, double-click the Fibre folder.
The information for the port appears in the tree.
5.
Right-click any port icon in the Port tree, and select Default Setting(User Name/Secret) from
the pop-up menu.
The Default Setting(User Name/Secret) dialog box (
) appears. In this dialog box,
specify the following user information.
•
User Name
Specify the user name for Fibre Channel with up to 16 characters. You can use
alphanumeric characters in a user name. User names are case-sensitive.
•
Secret
Specify the secret (that is, a password used in CHAP authentication) in 12 to 32 characters.
You can use alphanumeric characters, spaces, and the following symbols in a secret:
. - + @ _ = : / [ ] , ~
•
Re-enter Secret
Specify the secret, again, for confirmation.
6.
Click the OK button to close the Default Setting(User Name/Secret) dialog box.
7.
Click the Apply button in the Authentication window.
A message appears and asks if you want to apply the setting to the storage system.
8.
Click the OK button to close the message.
The setting is applied to the storage system.
Figure 36 Default Setting(User Name/Secret) Dialog Box
Switch Authentication
Setting Switch User Information
To register user information on a Fibre Channel switch:
1.
Make sure that Remote Web Console is in Modify mode.
2.
Start LUN Manager and display the Authentication window (
).
Setting Fibre Channel Authentication
55