HP ProLiant WS460c Gen8 Graphics Server Blade - Manual (Page 62)

Hardware options installation 62
9. Install the TPM board. Press down on the connector to seat the board (" System board components " on
page 10 ).
10. Install the TPM security rivet by pressing the rivet firmly into the system board.
11. Install the front panel/drive cage assembly.
12. Install the SAS controller (on page 19 ).
13. Install the DIMM baffle.
14. Install the access panel (on page 16 ).
15. Install the workstation blade (" Installing a server blade " on page 40 ).
16. Power up the workstation blade (on page 14 ).
Retaining the recovery key/password
The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of system
integrity.