Remove the workstation blade – HP ProLiant WS460c Gen8 Graphics Server Blade User Manual

Page 15

Operations 15

This command initiates a controlled shutdown of applications and the OS before the workstation

blade enters standby mode.

poweroff server [bay number] force
This form of the command forces the workstation blade to enter standby mode without properly
exiting applications and the OS. If an application stops responding, this method forces a shutdown.

•

Use the Onboard Administrator GUI to initiate a shutdown:

Select the Enclosure Information tab.

In the Device Bays item, select the Overall checkbox.

From the Virtual Power menu, initiate a shutdown of applications and the OS:

—

For a controlled shutdown, select Momentary Press.

—

For an emergency shutdown, select Press and Hold.

Before proceeding, verify the workstation blade is in standby mode by observing that the system power LED

is amber.

Remove the workstation blade

To remove the component:

Identify the proper workstation blade.

Power down the workstation blade (on page

Remove the workstation blade.

Place the workstation blade on a flat, level work surface.

WARNING:

To reduce the risk of personal injury from hot surfaces, allow the drives and the

internal system components to cool before touching them.

CAUTION:

To prevent damage to electrical components, properly ground the workstation blade

before beginning any installation procedure. Improper grounding can cause ESD.