HP ProLiant WS460c Gen8 Graphics Server Blade - Manual (Page 54)

Hardware options installation 54
7. Install the DIMM.
8. Install all DIMM baffles.
9. Install the access panel (on page 16 ).
To configure the memory mode, use RBSU (" HP ROM-Based Setup Utility " on page 72 ).
Mezzanine card option
Optional mezzanine cards are classified as Type A mezzanine cards and Type B mezzanine cards. The type
of the mezzanine card determines where it can be installed in the workstation blade.
• Install Type A mezzanine cards on Mezzanine 1 connector or Mezzanine 2 connector.
• Install Type B mezzanine cards on Mezzanine 2 connector.
Optional mezzanine cards enable network connectivity or provide Fibre Channel support. For mezzanine
card locations, see the system board components (on page 10 ).
When installing a mezzanine option on mezzanine connector 2, processor 2 must be installed.
For mezzanine card mapping, see the HP ProLiant WS460c Gen8 Graphics Server Blade and Expansion
Blade Installation Instructions or see "Interconnect bay numbering and device mapping (on page
38 )."
To install the component:
1. Power down the workstation blade (on page 14 ).
2. Remove the workstation blade (on page 15 ).
3. Remove the access panel (on page 16 ).