HP ProLiant WS460c Gen8 Graphics Server Blade - Manual (Page 60)

Hardware options installation 60
o Route the cable along the right DIMM baffle and connect the cable to the SAS controller.
o Route the cable along the left DIMM baffle and connect the cable to the mezzanine option.
6. Install the access panel (on page 16 ).
7. Install the workstation blade (" Installing a server blade " on page 40 ).
HP Trusted Platform Module option
For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP Product Bulletin website (
http://www.hp.com/go/productbulletin ).
Use these instructions to install and enable a TPM on a supported workstation blade. This procedure includes
three sections:
1. Installing the Trusted Platform Module board (on page 61 ).
2. Retaining the recovery key/password (on page 62 ).
3. Enabling the Trusted Platform Module (on page 63 ).
Enabling the TPM requires accessing RBSU (" HP ROM-Based Setup Utility " on page 72 ). For more
information about RBSU, see the HP website ( http://www.hp.com/support/rbsu ).
TPM installation requires the use of drive encryption technology, such as the Microsoft Windows BitLocker
Drive Encryption feature. For more information on BitLocker, see the Microsoft website
(
http://www.microsoft.com ).
CAUTION: Always observe the guidelines in this document. Failure to follow these guidelines
can cause hardware damage or halt data access.