HP ProLiant WS460c Gen8 Graphics Server Blade - Manual (Page 32)

Operations 32
For software installation information, see the Microsoft Windows on HP ProLiant WS460c Gen8
Workstation Blade with WS460c Graphics Expansion Blade Administrator Guide.
Install the NVIDIA GRID K1 or K2 graphics card
Required tools for this procedure:
• T-10/T-15 Torx screwdriver (provided inside the server)
• HP Insight Diagnostics software
For basic installation instructions, follow these steps.
To remove the graphics cards from the graphics expansion blade:
1. Power down the workstation blade (on page 14 ).
2. Remove the workstation blade.
3. Remove the WS460c Graphics Expansion Blade access panel (on page 20 ).
4. Remove the WS460c Graphics Expansion Blade PCIe card cage (on page 23 ).
5. Disconnect any power cables from the graphics card, disconnect the retaining screws, and then remove
the graphics card from the card cage.
6. Install the new graphics card into the card cage, connect any power cables to the graphic card, and
then tighten the retaining screws.
7. Connect the WS460c Graphics Expansion Blade PCIe card cage.
8. Install the WS460c Graphics Expansion Blade access panel.
9. Install the workstation blade into the enclosure.
10. Power up the workstation blade.
11. Download and install the latest drivers from the HP website ( http://www.hp.com ) or NVIDIA website
( http://www.nvidia.com/content/drivers/drivers.asp ).
For software installation information, see the Microsoft Windows on HP ProLiant WS460c Gen8
Workstation Blade with WS460c Graphics Expansion Blade Administrator Guide.
Install the NVIDIA Tesla K20 or Tesla K20X I/O Plate
Required tools for this procedure:
• NVIDIA GRID K20 I/O plate or NVIDIA GRID K20X I/O plate
• M2.5x6 mm flat head screws (3)
• M2.5x6 mm wafer head screw (1)