Setup, Overview, Installing an hp bladesystem c-class enclosure – HP ProLiant WS460c Gen8 Graphics Server Blade User Manual
Page 37: Installing server blade options, Installing interconnect modules
Setup 37
Setup
Overview
Installation of a workstation blade requires the following steps:
1.
Install and configure an HP BladeSystem c-Class enclosure.
2.
Install any workstation blade options.
3.
Install interconnect modules in the enclosure.
4.
Connect the interconnect modules to the network.
5.
Install a workstation blade.
6.
Complete the workstation blade configuration.
Installing an HP BladeSystem c-Class enclosure
Before performing any workstation blade-specific procedures, install an HP BladeSystem c-Class enclosure.
The most current documentation for workstation blades and other HP BladeSystem components is available
at the HP website
Documentation is also available in the following locations:
•
Documentation CD that ships with the enclosure
•
HP website
Installing server blade options
Before installing and initializing the workstation blade, install any workstation blade options, such as an
additional processor, hard drive, or mezzanine card.
Installing interconnect modules
For specific steps to install interconnect modules, see the documentation that ships with the interconnect
module.