Changing copy pair status – HP XP P9000 Command View Advanced Edition Software User Manual
Page 212
TIP:
As of Replication Manager version 6.3, mainframe pair status information can be obtained using
Device Manager (without HP StorageWorks P9000 for Business Continuity Manager Software or
P9000 mainframe agent installed). Detailed pair state information for mainframe pairs in Device
Manager is equivalent to the information for open systems pairs shown in
.
Legend:
--: Not applicable
Cnt Ac-S: Continuous Access Synchronous
Cnt Ac-A: Continuous Access Asynchronous
Cnt Ac-J: Continuous Access Journal
BC: Business Copy
1.
If HP StorageWorks P9000 for Business Continuity Manager Software 5.0 is being used, the
status of the primary volume is
SUSPCU
, and the status of the secondary volume is
SWAPPING
,
the copy pair status is displayed as
SUSPCU
in HP StorageWorks P9000 for Business Continuity
Manager Software and
Split (SW)
in Replication Manager.
2.
If HP StorageWorks P9000 for Business Continuity Manager Software 5.0 is being used, the
status of the primary volume is
SUSPER
, and the status of the secondary volume is
SWAPPING
,
the copy pair status is displayed as
SUSPER
in HP StorageWorks P9000 for Business Continuity
Manager Software and
Split (SW)
in Replication Manager.
3.
If HP StorageWorks P9000 for Business Continuity Manager Software 5.0 is being used, the
status of the primary volume is
DUPLEX
, and the status of the secondary volume is
SWAPPING
,
the copy pair status is displayed as
PENDING
in HP StorageWorks P9000 for Business Continuity
Manager Software and
Split (SW)
in Replication Manager.
4.
Suspending
,
Copying
or
Deleting (TRANS)
is the actual status, but in Replication Manager
this is abbreviated as
Suspending
or
Deleting (TRANS)
.
Changing copy pair status
Replication Manager allows you to change the copy pair status in open systems and mainframe
systems. Pair status change operations may be necessary to resume copy operations after recovery
from an error or unexpected pair status changes.
NOTE:
The Change Pair Status Wizard also supports site recovery operations for open systems. See “
pair operations and recovery scenarios
” on page 229 for more information.
Related topics
• About changing copy pair status
• Advanced pair operations and recovery scenarios
Managing pair life cycle
212