HP 8.20q Fibre Channel Switch - Manual (Page 22)

22 Installing, Upgrading, and Removing Simple SAN Connection Manager
The following is returned:
qla2xxx_conf 303752 1
qla2xxx 982688 0
scsi_mod 445298 qla2xxx
c. To verify that the correct driver is loaded, issue the following command:
# cat /proc/scsi/qla2xxx/* | grep "Driver version"
The following is returned:
Firmware version: 3.03.25 IPX
Driver version: 8.02.23-fo
Removing Simple SAN Connection Manager
Simple SAN Connection Manager uses the installation wizard to remove all components currently installed.
You must reboot your computer following program removal. Follow the procedure for removing Simple
SAN Connection Manager from Windows “Removing Simple SAN Connection Manager in Windows,”
page 22 or Linux “Removing Simple SAN Connection Manager in Linux,” page 23.
Removing Simple SAN Connection Manager in Windows
Follow these steps to remove the Simple SAN Connection Manager software from a server running
Windows.
1. Insert the installation CD into your computer’s CD-ROM drive.
The HP Installation Wizard starts automatically.
The initial installation window (
Figure 8 ) opens.
Figure 8 Installation wizard: initial window for program removal
2. Click Remove Programs.
A message box asks if you are sure you want to remove the program.
3. Click Yes to proceed with program removal, or No to cancel.