HP Designjet 4500 Printer series - Manual (Page 72)

7. Slide drawer 1 forwards to gain better access for the front screw. Fix the left side of the stand to
the printer using two screws. Make sure that the screws are fully tightened.
Attach the roll module
Before unpacking the roll module, note that you should handle this piece of equipment using only the
points indicated by the green arrows.
1. Open the box containing the roll module, then remove the two foam supports.
2. Remove the roll module from the packaging box.
58 Chapter 3 How do I... (printer assembly topics) [4500] ENWW
How do I... (printer
assembly topics) [4500]